How Does Evapotranspiration Guide Watering?
As an Amazon Associate we earn from qualifying purchases.
Evapotranspiration is the water that leaves the soil by evaporation and leaves the plant by transpiration. Because that loss is driven by the same weather that dries the garden, it gives a way to match watering to what the plants have actually lost. This guide uses two extension publications to explain the idea, the lawn can method and where the sources stop.
At a glance
- Evapotranspiration is the amount of water that evaporates from the soil plus the amount that transpires through a plant’s leaves, according to Oregon State University Extension.
- Oregon State calls evapotranspiration “the easiest way to determine if you are over or under watering your lawn,” and describes a five-can test to measure how much water a sprinkler applies.
- The UC Cooperative Extension column for the Sierra foothills says July has the highest average rate of evapotranspiration in that region.
- Both sources recommend checking the soil and adjusting schedules as weather and season change, rather than watering on a fixed calendar.
What evapotranspiration measures
Evapotranspiration combines two processes. The UC column describes evaporation as water moving “into warm air or wind from a surface (such as the soil surface in your garden).” It describes transpiration as the process in which plants “take water up through their roots, use it in metabolic processes, and release it as water vapor through their leaves.”
Oregon State gives the working definition used in its lawn guide: evapotranspiration, measured in inches or millimeters, is “the amount of water that evaporates from the soil plus the amount of water that transpires through the leaves of a specific plant, in this case, lawn grass.” Measured this way, the figure describes the water demand of the plant and surface together.
Why the rate changes through the year
The UC column states that “Throughout the Sierra foothills, July is the month with the highest average rate of evapotranspiration.” It ties that peak to high temperatures. The same column says that as temperatures cool into fall, plants need less water, and that in winter it is usually not necessary to water at all in that region.
Oregon State gives a parallel instruction for lawns. It says to increase the amount of water over spring to reach summer needs, and to decrease it gradually in fall as winter rains approach. Its guide is written for Eastern Oregon, so the exact timing will differ in other climates. The principle, that demand rises with heat and falls with cooler weather, is the part the sources agree on.
The five-can test for lawns
Oregon State’s lawn method turns evapotranspiration into a practical schedule. The steps as written in the guide are as follows.
- Set five flat-bottom cans or coffee mugs at various places on the lawn, ideally halfway between sprinklers or in the areas that receive the least water. The guide says more than five may be needed on large lawns.
- Turn on the sprinkler for exactly 15 minutes.
- Measure the depth of water in each can, then find the average depth across all five.
- Use the seasonal chart in the guide to read how many minutes to water about every second or third day, and record the times for future reference.
The test shows how much water the system actually delivers, which matters because sprinklers rarely apply water evenly. Oregon State notes that a lawn surrounded by concrete or other heat-reflecting structures may need slightly more water. The guide also warns about the cost of getting this wrong: many residential landscapes are over-irrigated by as much as 20 to 40 percent, and overwatering can lead to disease problems and leaching of fertilizers.
The guide adds that in the Intermountain West, the daily weather pattern matters, and that a good schedule must account for the turf species, soil characteristics, shade from nearby trees and shrubs, mowing height, disease risk, and how much water the irrigation system can deliver. A single chart cannot account for all of these, so the chart is a starting point.
Using the idea in beds and containers
The UC column focuses on gardens rather than lawns. It advises adapting the watering schedule to weather and season, and it recommends feeling the soil around plants and digging down to root level to see whether there is enough moisture. In its example, tomatoes and pumpkins may need water every day during heat, which shows that demand differs by crop.
Mulch is one way to reduce the water a bed loses. The column says that “mulch on the surface can reduce water use by up to 50%,” and explains that mulch cools soil temperature and reduces evaporation, so water stays in the root zone longer. The column’s figure is a general claim from that source and is not tied to a specific garden.
The column also recommends low-volume drip or micro irrigation for gardens, trees, and shrubs, because slow application allows clay soils to absorb water and reduces evaporation, runoff, and overspray. For readers who want the soil side of the same question, the explainer how soil surface evaporation shifts between two stages describes how drying changes over time. For the root side of the transpiration figure, how roots find water covers how plants reach moisture in the soil.
What remains unclear
Both sources are regional. The UC column describes the Sierra foothills, and the Oregon State guide is for Eastern Oregon. Neither gives evapotranspiration values for other climates, so this article does not provide numbers for any specific location.
What the sources do not say
Neither source explains how to get daily evapotranspiration figures from a local weather station, and this article does not describe that method. Neither gives a formula for converting evapotranspiration into watering minutes for a bed or a shrub, beyond the lawn can test. The UC column does not provide a seasonal chart. The Oregon State chart shows minutes by season for specific depths, but the table layout in the source text is difficult to read reliably, so this article does not quote its figures.
Neither source covers drought-tolerant plant water needs in depth, and neither provides a tested schedule for vegetables or trees.
Frequently asked questions
Is evapotranspiration the same as evaporation?
No. Evaporation is the loss from the soil surface alone. Evapotranspiration adds the water that plants release through their leaves, according to the UC column’s description of both processes.
Why does evapotranspiration matter for watering?
It is a measure of how much water is leaving the soil and plants. Oregon State calls it the easiest way to tell whether a lawn is being over or under watered.
What is the five-can test?
It is Oregon State’s method for measuring how much water a sprinkler delivers. Five cans are placed across the lawn, the sprinkler runs for 15 minutes, and the average depth in the cans is read against a seasonal chart.
Does evapotranspiration change with the seasons?
Yes, according to both sources. The UC column identifies July as the month of highest average rate in the Sierra foothills, and Oregon State says to increase water in spring and reduce it in fall.
Does mulch change how much water a garden needs?
The UC column says surface mulch can reduce water use by up to 50% and reduces evaporation from the soil. The source makes that as a general claim, so the actual saving will depend on the garden.
Sources
- UC Cooperative Extension (Mother Lode), Becky Miller-Cripps, “Smart Irrigation in the Hot Summer Garden,” https://ccfruitandnuts.ucanr.edu/sites/default/files/2017-07/265955.pdf.
- Oregon State University Extension, Mary Corp and Chris Luttrell, “Lawn watering guide for Eastern Oregon,” published August 2010, reviewed 2024, https://extension.oregonstate.edu/es/gardening/lawn/lawn-watering-guide-eastern-oregon.



